[[start|Start]] - [[arduino-breadboard-modules|All Modules]] - [[arduino-breadboard-mosfet-modules|MOSFET modules]] - [[arduino-breadboard-module-mosfet1e|This is: MOSFET module 1E]]

A very small module, that can either support a big mosfet (TO-220 housing) or an on-board mosfet (TO-252 housing)

This module includes: 

   * a 100K pull-down resistor between mosfet pins GND and GATE (to ensure the OFF condition)
   * an ON LED
   * a fly-back diode (for those inductive loads)

For an on-board mosfet configuration, this module also includes

   * a Fuse (a 0603 single use fuse)
   * a Fuse error LED (if the fuse is blown)
   * a 10 ohm gate resistor (so it becomes easier/safer to do parallel mosfets)