Differences

This shows you the differences between two versions of the page.

--- arduino-breadboard-module-mosfet1e [2025/02/16 11:15] – created mralvin
+++ arduino-breadboard-module-mosfet1e [2025/02/16 12:15] (current) – mralvin
@@ Line 1: / Line 1: @@
-ToDo
+[[start|Start]] - [[arduino-breadboard-modules|All Modules]] - [[arduino-breadboard-mosfet-modules|MOSFET modules]] - [[arduino-breadboard-module-mosfet1e|This is: MOSFET module 1E]]
+A very small module, that can either support a big mosfet (TO-220 housing) or an on-board mosfet (TO-252 housing)
+This module includes:
+   * a 100K pull-down resistor between mosfet pins GND and GATE (to ensure the OFF condition)
+   * an ON LED
+   * a fly-back diode (for those inductive loads)
+For an on-board mosfet configuration, this module also includes
+   * a Fuse (a 0603 single use fuse)
+   * a Fuse error LED (if the fuse is blown)
+   * a 10 ohm gate resistor (so it becomes easier/safer to do parallel mosfets)