arduino-breadboard-module-mosfet1e
This is an old revision of the document!
Start - All Modules - MOSFET modules
A very small module, that can either support a big mosfet (TO-220 housing) or an on-board mosfet (TO-252 housing)
This module includes:
- a 100K pull-down resistor between mosfet pins GND and GATE (to ensure the OFF condition)
- an ON LED
- a fly-back diode (for those inductive loads)
In an on-board mosfet configuration, this module also includes
- a Fuse (a 0603 single use fuse)
- a Fuse error LED (if the fuse is blown)
- a 10 ohm gate resistor (so it becomes easier/safer to do parallel mosfets)
arduino-breadboard-module-mosfet1e.1739707901.txt.gz · Last modified: 2025/02/16 12:11 by mralvin